| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Help! Finish repair problems. http://www-.luthiersforum.com/forum/viewtopic.php?f=10137&t=53668 |
Page 1 of 1 |
| Author: | Stone67 [ Mon Nov 09, 2020 3:17 pm ] |
| Post subject: | Help! Finish repair problems. |
I made a mistake and damaged the finish with a screw from a jig when I was going to route a saddle slot The damage has passed through the finish into the wood. I tried filling with super glue but it stained the wood. Is there anything that can make the damage a little less visible. Does anyone have any suggestions?? |
|
| Author: | phavriluk [ Mon Nov 09, 2020 7:31 pm ] |
| Post subject: | Re: Help! Finish repair problems. |
OP, I'm sorry this mess is in front of you. My opinion, and it's just an opinion, is that once CA became involved, the goose was cooked. Using CA is generally no shortcut but a dead end except under the most carefully controlled, prior tested, conditions. Fear of CA is a healthy reaction. |
|
| Author: | Chris Pile [ Mon Nov 09, 2020 8:43 pm ] |
| Post subject: | Re: Help! Finish repair problems. |
Too bad. Should have touched it up with more finish. Quick and dirty didn't work in this case. |
|
| Author: | jfmckenna [ Wed Nov 11, 2020 9:13 am ] |
| Post subject: | Re: Help! Finish repair problems. |
What is the finish? |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|